A/C Condensate Draining

Use this section for questions and answers regarding technical aspects of your RV. Please give us details such as the make and model where applicable and a good description of the problem.

Moderator: Cal

A/C Condensate Draining

Postby flogator376 » Tue Aug 18, 2009 6:39 pm

I have a 2005 Keystone Hornet Travel Trailer. The A/C unit is a 15,00 btu unit by Coleman. I do
not have the model number at this time. My problem is: I have the TT setup on a concrete pad. The unit is leveled and the AC condensate is drainin from both sides of the roof. I want to direct the condensate drain to the rear or one side of the unit. Can a drain hose be placed on the unit to accomplish this?
flogator376
 
Posts: 1
Joined: Thu Jul 30, 2009 8:11 pm

Postby Eric J » Wed Aug 19, 2009 2:27 am

I dont have the answer on how to attach a drain to the pan? but I have a thought that may could work to help direct the water to one side of the camper?

Eternabond tape

could a strip (say 3 inch wide) be put down some where close to the path the water drains now and cut some 1 inch strips to stick down on each side of the 3 inch say 2 layers on top of each other and direct it to one side by doing so?
maybe some other people will chime in?
however it would be a catch all for leaves and small debris but they get caught around the AC unit anyway?

if you were able to attach a drain hose up their? the hose would also have to be attached up their some how so when in transport the wind would not have it flopping around up their?
Eric J
 
Posts: 444
Joined: Sat Sep 30, 2006 1:22 am

Postby Carl » Wed Aug 19, 2009 10:30 am

Mine drains right over the darn door and I have been thinking of building a mote around the thing with a channel going away and off the roof. The channel would be made from some plastic hose covered with Eternabond. I don't think you will find a drain hole in the pan like you do for house style ACs. When I replace my gasket in the near future, I am going to see if I can put a drain in the pan. Carl
Carl
 
Posts: 989
Joined: Thu Sep 08, 2005 3:59 pm
Location: Orlando Florida

A/c condensate draining

Postby petenkathy » Wed Aug 19, 2009 1:33 pm

It sounds to me like you guys are too perfect. When I set up my unit I always set it up a tiny bit off level in the back so my air conditioners drain off the back. This isn't enough to mess with the refrigerator it just keeps the water off the front door and to the rear, both rain and air conditioner. By the back I am talking the drivers side and even a little to the rear. It has always worked very well for me.
Pete and Kathy Callan
Were full timers for 11 years
petenkathy
 
Posts: 104
Joined: Sat Sep 24, 2005 4:01 pm
Location: Fort Worth Texas

Postby Russ Chastain » Wed Aug 19, 2009 4:02 pm

My gutter funnels it away from my door... although there's a seam in the gutter farther back that I never sealed, and it likes to leak there.

Pete, my big rig has a roof that's pitched both right and left. Where the condensate runs is determined by which side of the unit it comes out of. And it likes to come out the right side, hence the condensate always runs down the door side of the trailer. The rig would have to be extremely off-level to make it run towards the back (left) side of the trailer.
- Russ
Russ Chastain
 
Posts: 1657
Joined: Tue Sep 06, 2005 1:33 am
Location: Florida, USA

Postby Eric J » Wed Aug 19, 2009 10:57 pm

my roof is higher in the rear than the front, no way it would/could ever drain to the rear, however like Russ it drains into the gutter strip on which ever side it happens to run off to which seems to be the the side the door is on most of the time. the lil gutter strip does work well tho.

pete, in my opinion if their is one thing to have level it would be the frig.
I think it was mickey? that posted this.....

Any chance the rig has been parked on an un-level surface? Operation sounds like what may happen if not level while parked with frig running for some time. Some of the chromate in with the ammonia has gotten over heated and has partially crystallized and is partially blocking the flow of ammonia. Once chromate has crystallized, reduced cooling will happen on both power sources.

dont think it will happen quick but, shortin the life of it?
Eric J
 
Posts: 444
Joined: Sat Sep 30, 2006 1:22 am


Return to Technical Questions and Reader responses

Who is online

Users browsing this forum: No registered users and 0 guests

cron